Hammer parts Drum perforator repair
Posted: Tue Feb 18, 2025 7:09 am
If there is noticeable heating, it is necessary to stop the work and wait until it cools down. Water cannot be used for cooling, its use can damage the gearbox parts.
Work with the tool should be carried out in the following mode - at least a 10-minute break after half an hour of work.
DIY repairs
You can only partially repair a hammer drill yourself. But, for example, it is better to perform such a unit as an electric motor in a special workshop.
It is best to have the repair done at the warranty workshop of the company from which it was purchased.
To lubricate the hammer drill components, use only those materials recommended by the manufacturer.
A barrel hammer drill differs from a traditional one in that the electric motor is located vertically and it cannot operate in drilling mode.
Barrel drill SDS-plus Intertool DT-0182
Therefore, due to the design features, in order to get to certain units, additional operations will have to be performed, in particular, to inspect the electric motor, it is necessary to remove the lower part of the australia telegram data casing or cover.And for replacing the brushes, the housing has special technological holes.
Replacing the power button
To replace this button, you will have to disassemble the case, disconnect it and install a new one in its place.
Replacing brushes
To replace the brushes, you need to provide access to the brush assembly. To replace, you need to release the brushes from the lock and install new ones in their place.
Bearing replacement
If you hear extraneous sounds when the hammer drill is working, then there is a high probability that the bearing has reached a certain level of wear. That is, it needs to be replaced.
Bearing replacement
To do this, it is necessary to completely or partially disassemble the housing and gain access to the unit in which it is installed. A puller may be required to dismantle it. By the way, some bearings can be secured with retaining rings.
Work with the tool should be carried out in the following mode - at least a 10-minute break after half an hour of work.
DIY repairs
You can only partially repair a hammer drill yourself. But, for example, it is better to perform such a unit as an electric motor in a special workshop.
It is best to have the repair done at the warranty workshop of the company from which it was purchased.
To lubricate the hammer drill components, use only those materials recommended by the manufacturer.
A barrel hammer drill differs from a traditional one in that the electric motor is located vertically and it cannot operate in drilling mode.
Barrel drill SDS-plus Intertool DT-0182
Therefore, due to the design features, in order to get to certain units, additional operations will have to be performed, in particular, to inspect the electric motor, it is necessary to remove the lower part of the australia telegram data casing or cover.And for replacing the brushes, the housing has special technological holes.
Replacing the power button
To replace this button, you will have to disassemble the case, disconnect it and install a new one in its place.
Replacing brushes
To replace the brushes, you need to provide access to the brush assembly. To replace, you need to release the brushes from the lock and install new ones in their place.
Bearing replacement
If you hear extraneous sounds when the hammer drill is working, then there is a high probability that the bearing has reached a certain level of wear. That is, it needs to be replaced.
Bearing replacement
To do this, it is necessary to completely or partially disassemble the housing and gain access to the unit in which it is installed. A puller may be required to dismantle it. By the way, some bearings can be secured with retaining rings.