Have you laid the wire?
Posted: Mon Feb 17, 2025 5:30 am
After taking all the measurements and removing the remains of the old winding, wind the wire onto the coils. Take a wire for rewinding electric motors with a diameter of 0.2 mm (this is an arbitrary value, everything depends on the specific model), solder it to lamellas No. 1. Pass the wire through the first groove, throwing it onto the shaft. From the first groove, bring the wire to the sixth (we repeat once again that everything must be done according to your measurements), winding the required number of turns. Solder the wire to the second lamella, pass it to the first and sixth grooves. Spray the required number of turns, solder to the third lamella. That's it, the first group is done.
Start the second group with the third lamella. Everything is done philippines telegram data similarly to the procedure described above. If everything is done correctly, then the end of the first turn should be exactly on the first lamella. This is how the winding of the motor winding is done.
Carefully wrap the cardboard, and to completely eliminate the breakage of the coils, it would not hurt to insert wedges. After this, you can fill the windings with varnish, but it is better to completely immerse them in varnish. It should be dried at a temperature of strictly 80-90 degrees Celsius (in the oven, at minimum heat). In a day, you will have a manually rewound anchor in your hands, which, if all the above instructions are correctly followed, will work no worse than the "native" one. This is how rewinding occurs
A single-phase asynchronous electric motor with a squirrel-cage rotor must have a starting and working winding. Their calculation is carried out in the same way as the calculation of three-phase windings. asynchronous motors.
Number of wires in the slot of the working winding fits into 2/3 of the stator slot.
Start the second group with the third lamella. Everything is done philippines telegram data similarly to the procedure described above. If everything is done correctly, then the end of the first turn should be exactly on the first lamella. This is how the winding of the motor winding is done.
Carefully wrap the cardboard, and to completely eliminate the breakage of the coils, it would not hurt to insert wedges. After this, you can fill the windings with varnish, but it is better to completely immerse them in varnish. It should be dried at a temperature of strictly 80-90 degrees Celsius (in the oven, at minimum heat). In a day, you will have a manually rewound anchor in your hands, which, if all the above instructions are correctly followed, will work no worse than the "native" one. This is how rewinding occurs
A single-phase asynchronous electric motor with a squirrel-cage rotor must have a starting and working winding. Their calculation is carried out in the same way as the calculation of three-phase windings. asynchronous motors.
Number of wires in the slot of the working winding fits into 2/3 of the stator slot.